Anybody getting Paradigm Studio 100's to image?

I've got the Studio 60's V1. I've got them imaging just fine, definatly Bi-wire them and assuming your electronics are good enough you'll be there. All the little things matter with micro current issues that enable imaging.
Use good interconnects and speaker cables to enable these micro currents to be passed along, give it the cleanest power you can (dedicated outlets, or power conditioner) to keep the AC grunge from obscuring things. Put good isolation thingies underneath you components (sorbethane pucks or vibrapods are cheap). All these things mattered in getting my Digm's to image.

I have the 100 v3's and they image rather well, especially to the center. It was crucial for my setup to have them positioned juuuuuuuust right, toed in, with the imaginary lines from the drivers meeting at the apex of a triangle about 1 foot behind the listener's head. Imaging was good with the original amp, a B&K ST140, improved with Dakiom Feedback stabilizers, then seemed to improve again with Odyssey Extreme Monos (what a huge jump up in sound quality THAT was!), and then got less "bright" with second generation Dakiom stabilizers. The original 100's and the version 2's did not seem quite as good as the V3's when I listened to them, though (but listening time with those earlier versions is limited).

Also, still not totally satisfied with the treble (very good, but still a little harsh, IMO) and may switch to another speaker such as Lorelei's by Odyssey.

Oh yes, and as Richmon said, DEFINITELY bi-wire, an instant and immediately noticeable improvement in imaging. Very important point.

ALso VERY important to keep the bi-wires apart for the entire run by AT LEAST a few inches. Bi-wire cables that are all together in one sleeve should be avoided. 2 seperate runs are the best.