Pre-amp or cd direct to XA30.5 ?


I'm new to this, and this is my first forum.. so here goes. I have an old set of Tannoy D700's and have purchased a Pass Labs XA30.5 amp. I'm questioning
if I must adhere to traditional pre-amp (probably X2.5 or X1 2nd hand), or can I go direct from cd player with say digital inputs and volume control (say modwright oppo 105) or wadia? Any thoughts.. My reason for against pre amp is simply don't need that many inputs. Ideas pls.. and tks for any advise ..
fsyme
As long as the source device has VARIABLE volume control, sure you can go direct into the XA-30.5 amp.

Some sources have both fixed and variable outputs. Make sure you use the correct one!
Your Pass XA30.5 has 30kohm input impedance, this is fine for you to direct connect from a source that has a digital domain volume control.
Just remember that some digital volume controls can "bit strip" if used below 2/3rds of full output.
Bit striping is a loss of bits, IE: instead of 16bit resolution it can be 14bit at volumes less than 2/3rds, which in some cases is not too bad as 14bit has a softer sound, which is better for background music anyway, such as dinner party music.

Cheers George
Many tks. If direct.. was thinking Wadia or Esoteric. I'll see if these have this "bit strap" issue.. Many tks for your help.
modwright advised against direct for their oppo 105... for bit stream issue (ie. Loss in sound quality).