2. analog
  3. 1378414454

Can Digital beat our Analog installations?

Having gone a long walk on developing my analog systems I am addicted to phono reproduction. Nevertheless I always kept an eye on CDs and also SACDs. Before I currently updated my digital dCS chain to the complete Scarlatti boxes I experimented on the best wordclocking connections. in the end I decided going for an additional rubidium clock added to my Verona master clock.

I am using also a second system equipped with the Accuphase 800 drive and 801 DAC, an Esoteric XO1 Limited and a Wadia 861 SE for other utilization. Let's concentrate on the dCS stack. These four boxes are sounding such good and analog like that I like to question my friends, Why isn't Digital an alternative to our best analogue chains?

So it's time comparing digital vs. analog systems and maybe some sophisticated digital chains are beating our sophisticated analog systems. Will it be possible?
thuchan
czarivey
5,946 posts
 
Cs, I will still love analogue!
thuchan OP
1,009 posts
 
Jfrech,
clocking cables are running from the clock to transport, dac and upsampler. from the external extension of the clock the bnc cable runs to the rubidium clock (perfection10). In this way the dCS clock is the master but getting more precision by the atomic power :-).

on wordclock cables i refer to the rules:

1. Use good quality 75ohm impedence cable.

2. All cables should be of equal length.

3. All cables should be a short as possible.

which cables are you using on the AES 2 connection using the Vivaldi mode and which Firewire cables do you prefer?
thuchan OP
1,009 posts
 
Thanks Lewm. I have submitted the congrats to my purchasement department. btw. they are also contracted on selling some of my units in the next time on Audiogon.
When the last of the four boxes of the Scarlatti system has arrived at me - the Scarlatti Upsampler then exchanges the Purcell - I will answer your question comparing the full system to the R 80.
jfrech's avatar
jfrech
1,816 posts
 
Hi, I've tried 3 types of clock cables. All were clearly audible. dCS Stock, Cardas Lightning 15 and Purist Proteus Provectus Praesto. I prefer the Purist out of these 3, however the Cardas is a lot better than stock. Seems to bring more focus and lower the noise floor...

Right now still using firewire (I've tried stock and audioquest diamond)....The audioquest again made a improvement...although I though the clock cables was more dramatic and crucial...go figure.

I have not updated to the new firmware yet for AES 2 off the transport to DAC. ( I just have the Scarlatti Trans, Clock and DAC) (have you?) Wonder if AES 2 vs firewire is better for SACD?

What do you notice with with out the rubidium clock as a reference? (and what brand model # pls)

Thanks in advance
buconero117
2,311 posts
 
Never! The physics of analogue can never be reproduced in the digital mode, no matter what sampling rate is used. Fact, just accept it.
More to discover