Upgrade: Turntable or Cartridge?

Lots of great suggestions and help here, much appreciated.

Regarding the decoupled motor, yes it is quite an annoyance. I don't notice it moving while a record is playing, but it mostly seems to move when I have to press the switch on the side of the motor on or off. I normally check to see if this has happened before I play a record by grabbing the tonearm with my thumb, index, and middle finger; if the motor has moved and is touching the plinth, I can feel vibrations coming into the tonearm. I then move the motor so that it's not touching the plinth at all. The old Clearaudio Emotion has a round "cut out" for the motor to fit into, so it's very easy for it to move just enough for any one point of the motor to make contact with the plinth; not a very good design choice. However, the bearing still seems to work very smoothly. I could probably benefit from a new belt though.

I actually ended up ordering a Dynavector 20x2L, which is being delivered today. I'm excited to put it into place, because now I'll be able to hopefully tell which audible limitations are due to the cartridge and/or turntable. Way back when I upgraded to the Emotion from a Music Hall MMF-5.1 about 4.5 years ago (it came with a Virtuoso cart), I do remember noticing less bass compared to the MMF, but can't recall exactly on the depth or quality of it. However, reading recent reviews of the Clearaudio Concept, they all point out that bass is not a particular strength of the unit. So it might be fair to say that historically, Clearaudio has chosen bass as a design compromise in its lower-priced 'tables.

If I were in your position I would change first turntable.
Let me explain.
In vain have the best cartridge in the world, if the cartridge can not show exactly what he can do.
The cartridge is the last to be changed.
I see so sequence change: turntable, arm and cartridge

Jwglista,

If the motor is moving because of a side-mounted on/off switch, which I agree is a poor design choice, try holding the motor down firmly with one hand while operating the switch with the other. Simple fixes for simple problems. :-)

If the motor *still* ends up touching the plinth despite this extra care, odds are the belt tension is pulling it there. A fix might involve any or all of:
- a less slippery surface beneath the motor feet
- less slippery motor feet
- lower tension on the belt
Each of these is likely to have audible effects too, but you must do something to prevent motor vibrations from transferring directly to the plinth and thence into the tonearm and cartridge. That's a guarantee of sonic mud and an excessively high sound floor.

As Manitunc stated, few if any vinyl rigs are set-and-forget devices. Their "convenience" resides mostly in a ready response to incessant tweaking!

Good luck and keep at it!

Jwglista

Congrats on the new cartridge. I'm using a karat with the Emotion TT with really nice results. One suggestion, consider the CMB upgrade for the Emotion. For far less than a new table, I found it to be a big jump in perofrmance.

sballs

To add a smidgeon to what Doug said, if the motor is however imperceptibly moving toward the platter during play, the speed of the turntable cannot remain constant. Another remedy: double-sided tape to immobilize the motor feet, and if that does not work - duct tape. At all costs, you need to immobilize the motor. Once that is done, check the speed with a reliable device. The best bang for the buck in that department is the KAB strobe. Calibrate speed if possible and you are done, so far as the particular other limitations of your tt will allow.