Benefit of low output moving-iron Grado ?

"Sound" advice, Photon. Until I'm in a position where amp upgrades are feasible from top to bottom, it seems clear I should stick with the high-output cartridge realm of analogue enjoyment. When it comes down to it, the Sonata has always sounded banging through my Vandy 3a Sigs, and a new, DEPENDABLE cartridge would breathe new life into my system. I am glad you are able to frankly and wisely share your experience with me in our comparable situations (though it looks like your system rocks pretty darn hard). And as far as the setup goes; you're right - the only thing I have to fear is fear itself.
So I suppose all my questions are answered, and perhaps I'll check in again, or send you a personal note once I replace the cartridge. Peace, Nicky

Bad writing skills, Nicky. What I meant by "dependable" was a modest upgrade (the high-output Master) which would be SIMILAR to what I've got and have been happy with (the Sonata), without gambling on a new phono stage. Whew...

You might want to experiment with loading. We had a ZYX Universe that was very nice, one day the needle just decided to let go of the cantilever and that was that.

So we installed a wood-body Grado we had on hand. Its 5mV. It was also a little upfront/in your face compared to the ZYX (we are running a Triplanar which easily tracks either cartridge). However being a high output moving magnet, they are sensitive to loading. We've used 10K as a loading value in the past, and that seems to work well with this one too.

Funny thing, if the arm really *can* track the cartridge, you have it set up right and loaded right, you really don't hear big differences between many cartridges. Miss one of the caveats above though and its a different story!

IOW we're not hearing a big difference between the two cartridges other than output. Loading in this case was the key as the Triplanar was not the variable.

I've been lurking around this thread as I too have a Reference Sonata and felt it was very brash, comparing it to my Zu DL103 on my other table. Tried the 10k loading and it did the trick. Much more laid back but did not lose any of the sparkle.

The smartass in me wanted to post that the Grado hum wouldn't be as loud. :)