2. analog
  3. 1389848984

VPI Classic platter - is center milled?

Is the vpi classic platter milled with a depression in the center? vpi recommends not using a mat, but my platter has a slight rise in the center.

With the provided ring clamp and gasket, vinyl stays 2 mm above platter with a lot of wobble. If I use the rubber mat, it seats the vinyl firmly.

Thanks for input.
abp689
ptmconsulting
1,000 posts
 
Just put any straight edge on the platter and you should know immediately
rcprince
3,073 posts
 
Very confusing. You sure you don't have the platter upside down? :^)
abp689 OP
41 posts
 
Reprince, Not really if it's upside down or not. I will call the factory and get back to you.
rcprince
3,073 posts
 
I was half-joking, but given the confusion I figured I'd ask. I know Jack, and I'm sure that he would know his product, so the conflicting answers indicate some confusion in the communications. Simple way for you to check would be to lift up the platter and check the other side, I guess.
brf
1,715 posts
 
Abp689, are sure you are not talking about the centre being raised when "using" the supplied rubber washer which is meant to be used with a reflex clamp???
More to discover