Even if you are using the same cartridge, it is VERY difficult to get identical settings when switching to a new arm/table. Small changes can have very large sonic consequences. Even a tiny VTA change will affect the apparent balance between bass and the upper end. Try adjusting VTA. Generally speaking, as one lowers the arm, bass becomes more prominent.
Basis 2200 Bass Issue
Hello,
I just purchased a used 2200 with a Vector 4 tonearm here on Agon, had it sent to Basis to be checked out and it was given a clean bill of health. Set it up last night, and I think I was careful and precise in following the directions. I have the table on a Vibraplane 2212, all Audio Research gear, Ref 2 SE Phono Pre, Ref 5 SE Pre, Ref 110 Amp, all Nordost TYR 2 Cabling. Bass sounds HORRIBLE! No balls, no slam, no texture. Had a VPI Classic 3 which sounded pretty great but my impression was that the 2200 was a superior table. Any insight or suggestions will be greatly appreciated, besides getting the Classic 3 back :) Thanks.
I just purchased a used 2200 with a Vector 4 tonearm here on Agon, had it sent to Basis to be checked out and it was given a clean bill of health. Set it up last night, and I think I was careful and precise in following the directions. I have the table on a Vibraplane 2212, all Audio Research gear, Ref 2 SE Phono Pre, Ref 5 SE Pre, Ref 110 Amp, all Nordost TYR 2 Cabling. Bass sounds HORRIBLE! No balls, no slam, no texture. Had a VPI Classic 3 which sounded pretty great but my impression was that the 2200 was a superior table. Any insight or suggestions will be greatly appreciated, besides getting the Classic 3 back :) Thanks.
- ...
- 15 posts total
- 15 posts total