2. analog
  3. 1390867966

empire 980 arm mistracks with various cartridges

Hi I have Empire 598 with 980 arm that mistracks with all cartridges used. All carts function fine in other turntables.
No matter how heavy I set up the VTF going way over limit of the cartridge specified it will still mistrack and would not output anything bellow 160Hz. So all bottom end is completely sliced away. When I tap on the plinth, bass comes back for the flash moment.
So far connected ADC Series II, Pickering XV15, Shelter 501 with no success. What may cause such brutal mistracking and lack of resolution?
czarivey
czarivey OP
5,946 posts
 
I finally came up with great arm AudioTechnica 1005 that landed onto the suspension spider just like the original one.
The smallish disadvantage that there's no arm lift(may acquire and mount externally and absence of magnet to pull up at the end of the dead wax.
Cartridge being used is Pickering XV15 with D750 styli. I think this table may deserve better cartridge, but so far sounds fantastic. Can any recommend MM cartridge $150ish ballpark?
THANKS for input!
atmasphere's avatar
atmasphere
11,861 posts
 
A Grado might suit nicely. I can't imagine the suspension of the cantilever is any good after so many decades.
czarivey OP
5,946 posts
 
Thanks Ralph,
I may try to look at Grado models at needledoctor, but probably will also try to slide a new needle onto XV15 cartridge that may be worth trying. Suspension of the cantilever truly not in the best shape, but visually unmounted looks perfect.
atmasphere's avatar
atmasphere
11,861 posts
 
Suspensions tend to perish over time so they can look fine but not sound right.
dougdeacon
3,338 posts
 
Unless you have scanning electron microscopes for eyes, you can't see the deterioration of the elastomers used in cartridge suspensions.

You may see the result if the cartridge bottoms out. Long before that, however, you'll hear the loss of elasticity in blah dynamics and boring sound.
More to discover