2. analog
  3. 1394259610

Kl Audio LP200 ultrasonic record cleaner insights

I did a bit of research a few months ago on the Audio Desk ultrasonic cleaner and thats where I found out about the KL Audio CLN LP200unit. I was attracted to the much more powerful motor, no rollers to replace and using distilled water rather than a cleaner.

Let me start that I have a Loricraft and used the Walker 4 step program but shortened it to a clean\rinse setup. Still ten undivided minutes of your time a side to clean. After a while I didnt bother with mint or new records.

Table Galibier Gavia, Triplanar Arm, Zyx Universe cartridge

I have quckly and efficiently cleaned more records in 3 weeks than I have for the three years I have had the Loricraft. And it was hardly an inconvienance, not a major chore

I have cleaned a number of Walker\Loricraft records again with the KL Audio. The results are jaw dropping. Dead quiet, no static pops (sometimes dont even zerostat). The biggest issue is resolution, getting down and removing that last bit of material and the resolution, body, separation of instruments, timing, passion and air around the notes is enhanced. Modest pressing sound like audiophile. I have ran into a few noisy records, probably dug out by the last stylus but most everything else has been so overwhelming. Low level detail is to die for.

The machine is a tank. Everything impeccably manufacturered. You can set the ultrasonic to 1-5 minutes and the drying 2-4 minutes I spit out a record every 5 minutes while I watch tv from the next room. It drys very effectively but isnt that loud

This machine is not cheap at $4k but what it does is like a very serious component upgrade. Highly recommended for someone with a serious vinyl collection and setup
128x128audiotomb
almandog
141 posts
 
Thanks for your comments.
I am using VPI Classic 3 TT with Ortofon Rondo Bronze cartridge. I clean it very often when I am listening. On the Klaudio, I do hear the loud buzzing sound from it while I am in another room. I even hear it with the door closed. I have started to do I preclean with Spinrite, before cleaning with Klaudio. I will take all your tips into consideration while I clean records next time. I will go to a record sale next weekend and get some more records. I will report back. Like I said before, I am not knocking Klaudio I just want to be sure that I get the most out of it.
almandog
141 posts
 
I was at THE SHOW this weekend in New Port Beach and I stopped by Klaudio Booth. I spoke to them about my experience with the uint, and I got some good information from them about it. I even asked about the bubbles I mentioned before, and it is not an issue. I bought some used records at the show so I have to do some more cleaning to do. Klaudio also have two new accessories for the unit. There is an attachment to the unit that hold 5 LP and drop and remove each LP into the LP Slot after cleaning; this is done automatically after loading the 5 LPs. There is also an acrelic box (not really a box) that the Klaudio fits into, that has a power supply and two fans at the bottom of the box for cooling. There is a door that closes after you load the record and you can see the entire operation, but you can ahrdly hear the Klaudio after the door is shut. This is great for cleaning records in your listening room because of how quiet it gets.They did not have prices for these accessories.
almandog
141 posts
 
Update:

Before cleaning the records I bought at The Show, I emptied the water from KLaudio. I took a clean piece of tissue to clean out reservoir and I could not believe what I saw. The tissue looked like mud was all over it. There was a lot of residue and brown muck in the reservoir. This means that the KLaudio is doing its job in getting muck from inside the recors groves. One thing I did motice is that Klaudio does not remove oil or finger print easily from the record. When I was cleaning the tecords, my finger soiled the record and I could see the big finger print that looks oily. I cleaned that record four times again and the finger print was still visible. Finally I took out my Spin Clean with some home made cleaning fluid and cleanes the record on it twice and I notice that about 90% of the finger print was gone. In fareness to KLaudio, they recommend that only plain water be used in the unit. Therefore I do not expect plain water to remove oil or finger print. By using the Spin Clean it clearly demonstrate to me that some chemical must be used to remove finger prints. I will use Spin Clean for finger print and oil from now on and Klaudio for deeper cleaning.
miner42
709 posts
 
Good regiment Almandog. When I get my Klaudio I will keep my Nitty Gritty Minipro2 for enzyme cleaning.
jtimothya
612 posts
 
One thing I did motice is that Klaudio does not remove oil or finger print easily from the record. When I was cleaning the tecords, my finger soiled the record and I could see the big finger print that looks oily. I cleaned that record four times again and the finger print was still visible.

This is where I wonder if the Audio Desk Systeme might do a better job cleaning than the KLAudio because the ADS unit uses a cleaning agent (surfactant?) and scrubs the record with its rollers.

Without claiming any science nor wanting to start a foodfight, it just 'seems like' cavitation + soap + scrubbing would do a better job than cavitation alone.

Who knows if that amounts to a practical difference.

 
More to discover