Upgrade Tonearm for VPI Aries 3


I have an Aries 3 turntable with JMW 10.5i tonearm.
I bought it new 7-8 years back.

I would like to upgrade the tonearm any suggestions ?
I use a Dynavector XX-2 Cartridge and I'll spend up to $3500 new or used.

I like the sound with the 10.5i but will upgrading the tonearm improve the sound ?

As time goes on I listen to more vinyl , almost every night.
Would it be better to purchase a used turntable with tonearm for $6000 ?

Thanks any input appreciated.
abill
Abill..If you do decide on a VPI arm, I strongly recommend the Discovery over the Nordost wires .....
Abill,
What is your current phono stage? Perhaps the money would be best spent in the phono stage and skip the new arm.

I went from a Zesto Audio Andros to a Simaudio Evolution 610 lp and the difference was staggering. Also, I added a silver cable as well
RE"Did you notice you had to continually make adjustments with the 10.5i arm ?"

No.

Check the counter weight hex bolt for tightness. It may be too loose, if so just tighten it up a bit. BTW, I have an Aries-3 also and two arm tubes, one with Discovery cable and the other with the Nordost.

M~
Moondog + Macster,

I will upgrade my preamp and phono within a few months.
I am considering a Herron line stage and phono or Coincident RC line stage and Zesto phono.

Currently I have a Supratek Cortese preamp with phono.

Records sound nice but it seems like I notice sss a little exaggerated and it is usually azimuth off a little.
I also notice my weight varies which is ok but I adjust it and sometimes the azimuth is off a little and I adjust it .

Eventually I will replace the tonearm and maybe table .
I enjoy listening to records and I would like a more solid tonearm that doesn't require constant adjustments.

And the counter weight is snug.

Thanks for the comments.
You have a unipivot tonearm that changes azimuth and VTF. A loose counterweight could do that but yours is ok. Does your arm clear the lift when playing? Are the tonearm wires binding between the arm and the connection block? Is the anti-skate ok? Is the cartridge suspension damaged? Is the point on the unipivot damaged? Is your counterweight hitting anything?