Trans-fi Terminator T3PRO opinions please...

Can't say enough good things about this tonearm. It is a little tricky adjusting it as mentioned but we'll worth it!

To add to my hurried response yesterday. Placing a record on the platter requires a bit of fineness as the arm structure remains over the platter. Not difficult, but you do need to exercise some caution. An air pump in another room is needed as I've never been able to sonically isolate one in the room. only a very small hole is needed to pass the airline tubing so that is easily accomplished. I have my pump plugged into a remotely powered power strip that also turns on two more strips that my gear is plugged int. One switch controls three strips, one of which is in another room. I sprung for the digital VTA readout but rarely use it. This is not a truly set it and forget it arm but the tweaks are simple and not a pain. Initial set-up is a little challenging but so are most arms. The sounds coming off the record speak for themselves. They just explode off in a way most pivoted arms seem to lack until you spend many times more. What have you got to lose? The used market will get you most of your money back I'm sure.

I concur with everything said previously. Much better than the fully modified RB 300 I used before. Also replaced Michelle gyro TT with Vic's Salvation TT. FWIW the best bargain in audio

I'm also on the verge of getting a Terminator.

Does Vic only ship them with the latest/greatest headshell (Tomahawk)? Or is there a "standard" headshell and an optional higher quality headshell?

Is it practical to use multiple headshells and easily swap them out? Would that, for all practical purposes, necessitate using the Molex termination? Aside from that one possible need, I would assume that the RCA termination would be preferable (due to being a more direct connection).

Hello Gary.

I use three arm wands for my three main cartridges: MM, MC mono, and MC stereo. It takes only a minute to change arm wands, but ...
1. with cartridges so expensive to replace, I take extreme care with stylus guards, etc.
2. each cartridge requires a different set of weights
3. it's only sane to check everything once it is installed
All in, 15-30 minutes, which is fine for an evening's listening, but not recommended after every record.

I use separate silver lines with ETI plugs for each arm wand because I really don't need an extra junction in the signal path. I expect that you will get the "latest and greatest" - but ask Vic. He is very helpful, and not rapacious in the least (hard to believe in our hobby, but there it is).