Installing Dedicated Lines.... Need advise

Contact VH audio and they can direct you. Their familiarity with numerous systems would be valuable. Also consider their panel mount AC filter and surge suppression. I just heard one installed at a friends. The improvement was not subtle. Jallen

Make sure you hire a qualified electrician who is also trained in stereo home installations. We can thank the popularity of home theater custom installation for electrical installation designed to reduce ground loops, hums, isolation etc.

My electrician suggested a separate pony panel from my main system. He also put in a large surge suppression to protect my equipment that would not impact sound quality. He also recommended separate lines for analogue and digital. All lines were designed for 20amp service.

Any electrician can wire a system for audio, but it takes good electrician to wire a system for both power and performance.

I suggest skipping the expensive romex and using a Topaz isolation transformer, preferably one that is at least 1000 watts or higher. These are common on Ebay for $250-$300.

I got great results by doing the following:

1. If the Topaz isolation transformer is 220V in/out capable, run a heavy gauge wire, 10-2 or 8-2 from the main panel to the Topaz and use the same gauge from the Topaz to a small subpanel...8 circuits or less. From the subpanel, run your separate dedicated standard 12-2 romex runs for each circuit.

2. If the Topaz is 110V out only, skip the subpanel and run the romex for the circuits directly from the Topaz

Doing the above reduced noise/hash in the mids to the point that my system went from sounding like very good detailed revealing hifi to producing a musical experience that was just enveloping.

Your mileage may vary.

For the outlets see this review thread:

http://forum.audiogon.com/cgi-bin/fr.pl?ymisc&1370875160&&&/Porter-Ports-or-Cabledyne-Cryo-Hubbell-5

I'm still thinking about doing this too.