2. cables
  3. 1386432333

Converting old amp to IEC power receptacle?

I have an older NAD 906 power amplifier that has an attached power cord. The built-in shelving which I want to put the system has a bunch of the previous owner's IEC cords already run behind the wall, etc. To use one of these, how difficult would it be to install an IEC receptacle in the NAD unit? I gather that since the original power cord was not grounded, that I should leave the ground tab of the IEC receptacle disconnected? Many thanks for any tips.
foodchain11
timrhu
2,779 posts
 
Way to go!
Replacing the 18 gauge inside the amp is way simpler than swapping out the receptacle. Might as well go all the way.
pixelphoto
70 posts
 
Foodchain11 please provide a link to the cutout template.
rodman99999
6,156 posts
 
What Timrhu said +1. Get rid of that bottleneck with better wire. Replacing the fuses with HI-FI Tuning or Synergistic Research will make a difference too(if you haven't already).
More to discover