UPgradeing dedicated line components

Thanks again, I am using #10 with 20 amp also. I plan on getting a IEC plug.

I really wasn't expecting that much of an improvement when I replaced the entry level Cu IEC from Furutech with the Furutech FR 48 R.

Wow.
I was curious if I would notice much if any improvement,because the entry level IEC Furutechs were much better than the stock ones, how much better could it get?
I am glad my curiosity got the better of me.

A bit off topic,but I also did another upgrade to the RCA connectors on my 25 foot IC.
They had decent WBT type locking connectors.
I replaced those with Furutech CR 102 R.

Again I wasn't expecting a great difference,the IEC replacement was a gem, could I get lucky twice?

Yes.

The sound just tightened up even more, more reverb details and trails, and a smoother sound to massed violins.
I never heard Lambchop Mr M, Antony and the Johnsons strings sound as clean and full bodied as they do now, and I haven't even put more than 2 hours on these upgrades.
If more playing time brings further enhancements,this will have proven to be one of my better upgrades.

The lesson I have learned is that the connectors play a crucial role in shaping the sound.

Moved to a new home 3 weeks ago and have just installed an upgraded dedicated circuit. Main panel is Cutler-Hammer CH series with copper bus bar, subpanel is GE Master Load Center with copper bus-bar. The subpanel is tied to the main with massive 6/4 conduit and I'm using 10/2 Romex (for now,...other options too pricey at 16-25 dollars per foot, with 5 outlets I needed about 150 feet of cable) BUT I have installed an Environmental Potentials EP-2050 on the main house panel to protect everything and an EP-2750 Ground Filter on the dedicated circuit. I have heard nothing but good things about the EP units and that combined with the copper busbar panels should be a nice upgrade in the entire system's sound....very excited to hear the result once i finish unpacking!

I envy you.If I could I would do the same.
Looking forward to your posts.

After the first 2 days of hearing the new circuit with the sub-panel and the EP 2050 and 2750 installed I can report the circuit is whisper quiet and even though all the components had been shutdown and boxed up for just short of a month, the system wow'ed me from the start. The EP units are not inexpensive nor was the electric work that was done however it definitely was well worth the time and cost to make it all happen.

I had to live without a dedicated circuit and full sub-panel install for many years for various reasons; this was well worth the wait!

Lacee: Took a look at your system listing; do you have any pics to post? It looks like a very nice selection of gear and I'd like to know how you've treated your room as I've never done a lot in this area as other things had to come first. The other thing to consider is that in the last house, a sub-panel was impossible both due to WAF as well as physical limitations. What I was able to have done back in 2008 was a single dedicated circuit, 1st breaker off the main, pulled with flex conduit and individual 10-gauge conductors to a j-box that split off into 2 different banks of outlets. The results with that too were worth the stretch and time/cost. Are you able to run conduit/wire of any kind where you are?