2. tech-talk
  3. 1381679264

DSPeaker Anti Mode 2.0 evaluation

I have read all of the glowing reviews of this product and I just don't understand why I am not impressed. I have been lucky to find a very kind dealer to allow me to try one the DSPeaker Anti Mode 2.0 units.
I have 2 JL Audio F113 subwoofers that I have set up in stereo and are based on their own microphones measurement calibration.

So, with those sub settings and then switching out the LF Filter, I then used the DSPeaker unit to eq just my JL subs. That is, I tested the unit by playing my Andra 2 speakers full range via my Pass Labs Preamp and Amp and with the other Preamp outputs I plugged in the DSPeaker in and then the JL subs are plugged into the DSPeaker.

I ran the DSPeaker calibration. I used the DSPeaker in and out of the flow by using its bypass button and I really couldn’t tell much of any improvement. In fact I believe I like the bypass sound better.

Why is this? All of the glowing reviews and it is only marginal different if at all.

Now, there is an update for the DSPeaker in June 2013 but my Norton Virus control will not allow the download. Perhaps, if I was able to download that update it would be better, but I doubt it.

So, before I end my trial of the unit, is my configuration flawed , what do you guys think?
128x128ozzy
ozzy's avatar
ozzy OP
7,497 posts
 
Well I was able to connect the DSPeaker direct to my Preamp. I still cannot detect any improvement using the DSPeaker calibration setting over just using the calibration from the JL Audio microphone.

Viewing the DSPeaker calibration graphs the correction is very minor except for a peak around 90-100 Hz. However, when in use the JL Audio Subs are crossed over at about 55 Hz so that peak would not matter.

Hopefully, once I try a different computer without the Norton protection I'll be able to download the latest June 2013 update there will be improvement.

Otherwise, the JL Audio Sub calibration appears to be pretty right on, making the DSPeaker irrelevant.
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
Ozzy, right-click on the Norton icon in the lower right corner of the screen and see if the menu that comes up offers a "disable protection" choice. If so, disable protection while you do the download and update. When you are finished, again right click on that icon and you will see a choice to re-enable protection.

Regards,
-- Al
ozzy's avatar
ozzy OP
7,497 posts
 
Thanks Al, I have now tried 3 separate computers and I was able to disable Norton. But each time I attempted the download at 6% and error message would pop up asking to retry but it never completes.
So, I guess that is that.
ozzy's avatar
ozzy OP
7,497 posts
 
Well I have determined that the unit I have been trying out is defective.
I will be getting a replacement next week.
lewinskih01
909 posts
 
Ozzy, how did you come to the conclusion it was defective?
More to discover