impedance match of preamp and main amp.


I am considering mating a Mcintosh Mc602 with a Bat Vk 51se. I noticed the input impedance on the Mc602 is 10K. While most Bat amps are much higher. Does anyone see a problem with this? It seems I remember a Stereophile I used to know told me about a ratio minimum of 1 to 25. I am not sure though.
cturnem
Thanks for all your help. I think I will look for an amp that matches my preamp. Maybe one of the BAT amps.
Cturnem, sounds like you want to keep your Bat preamp, and that Mac looks to be a nice amp, if your keen on owning it.

Your Bat preamp is a low 410ohms output impedance at most frequencies and into the Mac it has a good ratio of 1.24, the problem is in the bass, and as I said above this is an easy fix if you get a tech to change the Bat's output coupling capacitors to 4 x larger in uF. Then it will be a perfect 1:24 ratio at all frequencies.
This job to do should be around $100-$200 then your Bat will also be a match for any amp you purchase in the future as well.

Cheers George
Thanks,
Georgelofi. I believe what you are saying, but am not sure I want to make the VK 51se non stock( due to resale value) I am running a Classe CA 400 with the Bat. I think it is 70k input impedance. I am running B&W 800D speakers. I have no reason to want the MAC, except from reading all of the reviews, and it is more powerful. I have also considered the BAT VK 600Se. I have never owned anything MAC. What do you run?
I like big solid state, biased hard into class A with huge power supplies, and that has bi-polar output for great current delivery.

The Classe CA400 you have is no slouch either, I would be quite happy owning that even though they are Mosfet output.

Your Vk 51se should be happy into that 75kohm input impedance.

The B&W 800D's are a bit of a bitch to drive, if you can understand the test here.
http://www.stereophile.com/content/bampw-800-diamond-loudspeaker-measurements

I would be more likely to go the big class A bi-polars for these 800's like what I use. Things like the big high class A biased Krells, Mark Levinson's and such that use bi-polar output stages, for good current delivery for the 800's.

Cheers George
This thread has real good stuff / discussion . It helps me understand the application of "Ratio" better now - there is more to it than simple 1:10 min. . Thanks Georgelofi , Mapman , Almarg .