2. amps-preamps
  3. 1125851748

Tube preamp for a Bel Canto eVo2 Gen II

Right,
Don’t flame me for the mix & match system, I’m learning and growing as fast as I can. :-) I’m looking for a preamp (probably tube?) to go with a Bel Canto eVo2 Gen II. I’m thinking a “sweeter” tube preamp to balance out the potentially “dry” Bel Canto. Rest of the system is as follows. Musical Fidelity A3.2CD player, Spendor S9's.
Budget dictates $1000 - 1500 used for the preamp. Audio Mirror has some aesthetically pleasing preamps for very decent prices but I haven’t heard any in person. Other suggestions? Am I worrying too much about the eVo’s being “dry”?

Holding my breath until you reply,
Noexit Esq.
noexit
jasonsobel
29 posts
 
I would recommend a Grace Design m902 (or if you can find a model 901 used) headphone amp/pre-amp. While both are SS, they are among the smoothest, fullest, clearest, "musical" sounding pieces of gear that I have heard. Definitely worth looking into.

http://www.gracedesign.com/
dgordonl
128 posts
 
I have tested a handful of tube pre's on my SS setup and found the Manley Shrimp to match the best.Mind you my amps are not as dry as your BelCanto but mine are still on the bright side.
This pre seems to be very forgiving within a system...
And as a new unit it only retails for around $1800.00 new..
Matching is going to be a big problem!! for some pre's are a better match with their own seperates..Not the case with the Manley Shrimp.
garyk
30 posts
 
I use a tubed Herron VSTP-1A/166 with an eVo4 II and I'm quite happy. Ed Morawski in his Positive Feedback review of the eVo2 ( http://www.positive-feedback.com/Issue14/evo2.html ) used a tubed EAR 864.
rgodin
85 posts
 
The Bel Canto Evo 2, Gen II is neutral and accurate. It's also fast and detailed. I would not call it a dry amp.

I believe that Bel Canto used to recommend a minumim of a 10:1 ratio between the input impedance of the power amp and the output impedance of the preamp. You might want to check with them to be sure my numbers are correct and to avoid possible impedance mismatch problems.

I use a solid state preamp in my system, so I'll leave the tube recommendations to those with experience in that area.

Rick
noexit OP
5 posts
 
Yikes Newbie & Jafox, much ado about nothing IMHO. I’m new to “high-fi” and if you preview my one and only other post you’ll see the roots to my question. I’m 99% sure I’m buying a Bel Canto amp and I’ll be using my Creek 5350R as a “preamp” for the time being and didn’t want to have the system sound like mush in the interim.
Perhaps you should wait until that morning coffee before you post. :-)

Proud to have rode the short bus AND learned that arguing in a message board is like winning a gold medal in the special olympics .......

Noexit Esq.
More to discover