DO NOT run this unit on 120V! If there is any unregulated circuitry it may experience overvoltage conditions that could damage capacitors and the like. If it is all regulated, the regulators may not be able to handle the load.
A simple solution would be to get a control transformer with a 20-24Volt output that could be used to 'buck' the incoming AC line down by 20-24 volts. The output of said transformer would have to have the capacity to handle the current that the unit draws. This is a bit of a DIY approach and you should not attempt this unless fully qualified.
I would also contact Accuphase and at least find out if they are willing to help or not!
A simple solution would be to get a control transformer with a 20-24Volt output that could be used to 'buck' the incoming AC line down by 20-24 volts. The output of said transformer would have to have the capacity to handle the current that the unit draws. This is a bit of a DIY approach and you should not attempt this unless fully qualified.
I would also contact Accuphase and at least find out if they are willing to help or not!