TVC Gain effects

Would that go for any S&B tranny implementation, then? Hard to see why it wouldn't.

Does anyone have any guesses as to what could cause such an improvement with gain? Other than that the induced response variations end up correcting for some other problem in the chain?!

Does anyone have any guesses as to what could cause such an improvement with gain

You have current to spare -- but are lacking in voltage. I.e. yr source outputs a lot of energy -- but lower voltage than you like, or than the amp likes -- the latter admittedly, being strange as most amps reach their spec'd limit @~1,5V. (Upping the voltage on the tranny, you halve the current -- all other things being equal.)

My source is 2V and amps' sens. 1.1V. I'd "thought" that the +6 setting sounded better to me, too, but then I learned that I was wrong on paper. :-}

There are 2 explanations I can think of:

1) The higher gain setting will likely result in some sort of rolloff, probably at both ends of the frequency band. This could provide a filter effect, i.e. a synergistic effect that might be pleasant in some systems, through the mechanism of reduced bandwidth. Often that points to ultrasonic noise or other out-of band information (like actual audio information) that the power amplifier lacks the speed or power to reproduce without distortion.

2) TVCs can ring and are more easily loaded if used in the gain setting. It might be to your advantage to find out where critical damping occurs with the device, although that is probably tricky as it changes with each setting of the control. Hopefully the designer recognized this problem and built the loading into the unit, if so then #1 is your answer.