In What Order Do You Turn On/Off Gear Separates ?

I apologize that this thread is getting lengthy because of my lack of information. The amp (SS) takes at least 24 hours to warmup and sound its best. Consequently, I would just like to leave it on 24/7. The CD player (SS) manufacturer recommends that it remain on 24/7.

However, the manufacturer of the tube gear ~ 2 separate units: primary preamp and phono preamp ~ recommends that the tube gear be turned off after each play. So given these facts...

Which order to turn on/off?

Sounds like you only have one thing to turn on/off - and that is the tube preamp. You can always turn on your phono preamp with the tube preamp set to something else, which effectively mutes any "pop" the phono preamp would create. So it sounds like there is no question to answer here. If you can't turn the amps off momentarily to avoid the "pop", you have to just turn on the linestage preamp when you are ready to listen and suffer the pop.

My preamp (Hovland HP-100) must have some sort of internal muting circuit that turns off once the preamp is powered up, because I always turn my amps on first and never hear a pop. However, I pose the following questions:

How bad (i.e. loud, sudden, forceful) does a pop need to be before it risks damaging the downstream equipment? Can an amplifier be damaged by a "pop" (we hear pops when playing records...). Is the loudness of the "pop" associated with powering up a tube preamp at all dependent on the setting of the volume control? If a pop occurs in an empty room with nobody there to hear it, does it really make any sound? (whoops, I'm getting too zen here)...

Peter -- the "pop" can be many things, one of which is some dc... a low volume "pop" isn;t going to damage the spkrs, it's the unexpected eventuality of a loud pop that we're talking about here.

Mary: your only option is to switch OFF the pre first (because, when off, it cuts all upstream signals going to the amp) and switch ON the phono first, then the pre. As a precaution, let the gear lie without music for a minute before switching off.

Please note, however, that there shouldn't be any loud pops... (i.e. if there are, s/thing is slightly wrong).

Mary, please tell us what preamp and power amp you have. That may help you get the correct response for your situation. Some preamp manufacturer's absolutely recommend turning off the power amp first (and on second) because there can be a risk to your associated equipment. If your preamp has a muting circuit, you should be ok if you mute the output first then turn only the preamp off. I don't believe stuff on the input side should be affected. So, I would say either let us know the specific equipment you have, so someone here with directly related experience can answer you, or maybe more suitable in your case would be to call the preamp manufacturer directly. BTW, is any of this covered in your owner's manual?

Stevecham's advice is a common practice and this is also recommended by some surge protection manufactures. Some Panamax and Monster's models offer " sequential on/off". To turn on: source(s), pre, amp and to turn off: amp, pre,sources. The logic is source(s) and pre need to be on first to be stablelized before amp being turned on. You can find some explaination about sequential on/off feature in Panamax surge protection.