2. amps-preamps
  3. 1169401240

Mac's BAD MATCH for 802D's?

I have recently purchased B&W 802D's to go with my Mac C46 pre-amp and MC352 power amp.

A very respected dealer in my area (who has been helpful to me in the past) insists that Mac is about the worst possible match for the 802's and swears I would feel "like a veil was lifted" if I instead switched to Classe, Ayre (I do have an Ayre cd player, which I love), Mark Levinson or Boulder Amp. I should note that he does not carry some of these brands so he wasn't just trying to "sell" me. I have to admit that although my system sounds very good, it's not as "open" sounding (transparent, or whatever the right audiophile adjective might be).

If anyone aware of an engineering reasons the Mac might not be as great a match to the 802's as other equipment might be?

Any thoughts on what might be the optimal AMP combination (in a $6,000- $11,000 range) match for 802's
tomehunt
shiprepair
16 posts
 
Brian, I did go and listen to a pair of 802d and with the set up in the shop I preferred my old 801. It wasn't fair to the 802d as the turntable set up and preamp was rudimentary to say the least and even when listening to a CD it wasn't up to the old 801s playing vinyl. Interestingly the dealer did not offer to let me audition the 802ds at home. I thing the improvement would have been marginal if any.

However in chatting, the dealer recommended trying the 2ohm connection on the mc352 to the 801s. I did this on return home and I must confess, I also installed 2 Mallard tubes in my Jolida phono amp. I could not believe the result. I'm in awe. I have never heard such bass, clarity definition and translucency. I feel I have a new pair of speakers without forking out $12,000.00.

Thanks again as you set me on the right track.
brianmgrarcom
1,317 posts
 
That is interesting Shiprepair, it makes me wonder what the results would be if I tried the 2ohm taps, a friend encouraged me, but I never did.

Isn't it awesome when a simple tweak makes a difference as big, or bigger, that changing a piece of gear!?!

I still have fond memories of hearing your speakers at an audio store; I spent a lot of time at that store through the years, those were the first to wow me.
adamg
89 posts
 
I use a MC402 with a pair of B&W CDM 9NT (replaced by the 700 series). I am currently using the 8ohm tap. I recall trying the 4 ohm tap when I first received the amp and found the sound was much more dynamically restrained. Perhaps the CDM series are much easier to drive than the Nautilus models. However, I will give the 4ohm tap another try tonight after reading this thread!
More to discover