2. amps-preamps
  3. 1169466194

Air tight ATM 211 and MAXX

I have currently encountered a shocking and dreadful experience with Air tight ATM 211 mono amps. I did not unplug the amps for 5 or 6 days from AC outlet and after 6 days when I turned on the power amps in a few seconds a very loud and shocking noise appeared in the speakers which I had to rush and turn off the amps before they damage the speakers. The noise was so loud and striking that I thought I had burnt the speakers! What could be the reason and how can I avoid such problem.
Thanks for your advise.
fpooyandeh
samuellaudio
91 posts
 
did you get your problem fixed?
fpooyandeh OP
13 posts
 
Unfortunately the problem with DC current still exist in my amp which creat a very sharp loud noise in speakers. I was told to have my AC earthing checked but I do jot have any problem with my KRELL amps. I think it is a flaw with the air tight amps and pres with the design.
Any suggestionelec
aleko's avatar
aleko
33 posts
 
This is now very old forum but the outcome is not clear.
IMO the problem is not a as you say a 'DC problem' as the noise does not persist all time the amplifier is on.
I know that these amplifiers have a soft start curcuit.
There are 2 relays (2) which switch the high voltage after 60 seconds or so.
May it be a relay having its contacts stucked?
Why not have the relays checked by a technician - how they behave at switching the amplifier on?
Wish you luck
aleko's avatar
aleko
33 posts
 
Fpooyandeh,
Have you had the problem with the Air Tights fixed?
Appreciate if you let me know.
oneobgyn
410 posts
 
You'll blow the resistors on the MAXX if you have a power surge thus sparing the drivers. You should probably check them to make sure you don't need new resistors. Wilson Audio usually sends spare resistors in your kit.
More to discover