Nuforce with Stillpoints ERS fabric


Anyone ever try the Stillpoints ERS fabric with Nuforce amps? I have an RFI issue and wondering if this would take care of it. I only have the issue with my BAT VK-P5 phono pre. I get a buzz out of both channels and I have narrowed it down to RFI emmitted by the Nuforce amps. I have put my amps up for sale because of this, but if this will take care of it, I will keep them. I really like these amps and am hopining this will be the ticket.
Thanks
Jeff
jdodmead
Jdodmead,
I had a similar problem after purchasing a bel canto eVo6 which is also a switching amplifier. The amp forced me to clean up my AC. I removed all dimmers and flourescent lamps and installed a Dayton videa isolation transformer on my FM antenna cable lead and grounded my Marantz SR7200 chassis to my BBT PP1 power strip. My system is dead quiet now and I like the the amps power, tone, efficiency and the fact that it is good tool for testing the quality of your AC. I had ordered Stillpoints ERS cloth(6 adhesive sheets) before performing the above mentioned steps and it arrived after I had quieted my system. I lined the inside of my amp and Marantz DV8400 with the ERS Cloth anyway. I'm not sure if it made a difference but I have been very pleased with my system and have not had the urge to make any big changes.

My friend had a funny idea. Line the inside of a hat with the ERS Cloth. Has anyone tried this. I bet Harvey R. (Gizmo) would have.
ERS cloth on each Nuforce amp makes a significant improvement in my system. CAT preamp and Eidolon speakers and Shunyata King Cobras on everything.
Here's my guess: the NuForce amps are injecting RFI back into the power lines and emitting it in the air, so your BAT phono, which amplifies much smaller signals than line level, is most vulnerable. You can try installing a power conditioner (such as Exactpower or PS Audio products) where different outlets on it are isolated from each other, and use different outlets for the NuForce and BAT. On top of that, you can plug in noise filters into various AC outlets, like the Audioprism quiet line filters, AC Enacom and PS Audio Noise Harvester. Lastly, as Hals_den has mentioned, an isolation transformer should be able to completely isolate the amps (or phono) from AC noise. That takes care of the AC part.

Stillpoint ERS can partially filter out RFI/EMI emission from the amps, which is beneficial as well. There's also a device called Quantum Symphony Pro, which is designed to "neutralize" airborne RFI/EMI. It makes a big difference in sound, but I'm not sure if it removes the noise in your case. If you put all your gear on a rack, e.g., your phono in the middle and the amps at the bottom, you can stick a piece of u-Metal or copper foil at the bottom of the shelf supporting the phono, thus protecting the phono from being attacked from the bottom by the amps.

Good luck.
I gave up and sold the Nuforce, I love them, but time to move on. Now I have been scouring the ads for a replacement. Really having a hard time picking something. Should I or shouldn't I go back to tubes? Monos? Should I just buy something to tide me over until something really enticing hits? I have been wanting a VTL ST-150, but they don't show up very often.
My speakers are Von Schweikert VR4jr's and my pre is a VTL TL-5.5.
Thanks for all of your input on the RFI issue and sorry if I dissappointed you in my selling them off.
Jeff
The st-150 is the better choice anyway...Everything happens for a reason, and if you get the VTL, you will be far from disappointed.

Good Luck!