2. amps-preamps
  3. 1179615335

yamaha cx-1000u rs..can I run 2 subs?

I am wondering if I can hook up 2 subs useing this pre amp.I know its old.But you have to start somewhere.The manual doesn't say squat about subs,and I don't know too much about hooking them up.I have a wharfedale power cube 10 running on my ht setup.Thinking of useing that and maybe getting a svs pb10 nsd.Any input would be gr8!
ralphnoonan
rwwear
2,871 posts
 
Does it have more than one pair of audio outputs? If it doesn't you will need to use Y cables or the in and outs on the sub.
ralphnoonan OP
21 posts
 
Yes it does.Two sets.thank you.If I was going two upgrade to something from this decade and not go crazy with $,what would you recomend?I would like to be able two run maltipal amps and subs?
ralphnoonan OP
21 posts
 
I should've said,I now use nad power.Thinking of moving into anthem...not sure.
gregadd
574 posts
 
Do you have preamp out? If so, what I do is run the preamp out to xover/amp for your sub and back. Usually you will see a jumper cable, if you have an integrated amp or reciver. I run the left cable to left sub, etc. On my minsystem I use a y cable or connector. I asume you are using a powered sub w/xover.
More to discover