2. amps-preamps
  3. 1179615335

yamaha cx-1000u rs..can I run 2 subs?

I am wondering if I can hook up 2 subs useing this pre amp.I know its old.But you have to start somewhere.The manual doesn't say squat about subs,and I don't know too much about hooking them up.I have a wharfedale power cube 10 running on my ht setup.Thinking of useing that and maybe getting a svs pb10 nsd.Any input would be gr8!
ralphnoonan
ralphnoonan OP
21 posts
 
Yes it does.Two sets.thank you.If I was going two upgrade to something from this decade and not go crazy with $,what would you recomend?I would like to be able two run maltipal amps and subs?
ralphnoonan OP
21 posts
 
I should've said,I now use nad power.Thinking of moving into anthem...not sure.
gregadd
574 posts
 
Do you have preamp out? If so, what I do is run the preamp out to xover/amp for your sub and back. Usually you will see a jumper cable, if you have an integrated amp or reciver. I run the left cable to left sub, etc. On my minsystem I use a y cable or connector. I asume you are using a powered sub w/xover.
ralphnoonan OP
21 posts
 
on my preamp I have cd,tuner,tape1/dat2,tape3,cdv1,cdv2,vcr1,vcr2,output1,2..I also have optical connections?Are these better ways to connect things?
gregadd
574 posts
 
We are basically talking about outputs. That limits you to basically the tape loop and the preamp out.The fact that you have output 1&2 is good. That maximzes your options. I assume the outputs are in stereo?
More to discover