Is my amp "High Current"?

Wow, That was an excellent response. I finally saw the light bulb above my head go on. I only hope I can generate the watts to keep it lit :-)

Thank you. You really did explain that well.

"3. When impedance (ohms) drops, and the speaker wants lots of watts, you could give it A or B, but an electrostat would prefer A because it's a current hungry device, not a voltage hungry device like a cone driver which prefers B.
4. Tube amps (generally speaking) have more amps in each watt while SS amps have more volts in each watt,
5. Ergo, a 35 watt tube amp may be capable of delivering the same amount of CURRENT as a 200 watt SS amp.

So if it's current you're after, a good tube amp will do it -- if it's voltage you need, you'd be happier with the SS amp. The thing is, that unlike stats, cone drivers generally don't drop significantly in impedance as the frequency rises, however they do call for more power (in the form of volts not amps), when controlling (damping) large woofers."

Oh my. That's exactly backwards, Nsgarch.
.

"High Current is most commonly used to describe an amp with the ability to deliver increasing amounts of current into low impedence loads. The ideal amp would deliver twice the current as the load halves. For example, 100 watts into 8 ohms and 200 watts into 4."

Aren't Mcintosh some of the highest current amps on the market, and don't they claim their amps deliver the same power at 2, 4, and 8 ohms?

Jeffreybehr, please explain what's reversed. I'll fix it if it's wrong.

Here is what is wrong, Nsgarch. Electrostatics do not demand high current, but are voltage driven. In fact, all speakers respond to the voltage applied at the terminals, depending on their sensitivities. that is why sensitivity is stated as sound output (db)/2.83V into 8 ohms (which is 1 watt).
Thus, if a speaker outputs 90db at 2.83V input and it is an 8 ohms speaker (at that frequency) and we expect 90db at the same 2.83V input, but at a different frequency which is at 4 ohms, then the power requirement will be double, therefore the amps double.
Electroststics are essentially voltage driven devices, i.e. the membrane responds to the varying voltage of the stator panels. generally 'statics' don't demand a lot of current. Dynamic speakers also respond to voltage, but due to their drive systems, they also need power, thus the need for more current at lower impedences, therefore more amps. Note, if the amplifier is incapable of supplying the necessary current for the power demand, it is the voltage that sags, thus the output from the speaker 'sags'.
Tube amps are generally not great current producing devices beyond their power limits into specified loads, but their stability with voltage makes them a good marriage with electrostatics. High current capability SS amps do much better with varying impedence dynamic speakers than tubes, usually. That is the part that you had reversed, I think.
Respectfully, Bob P.