The long answer is yes, you can get a slight compression with the Lightspeed Attenuator if the input impedance of the poweramp is below the industry standard of 47k ie: 5k to 30k, because it will be being slightly loaded down.
If it is at or above 47k, the standard Lightspeed Attenuator WILL actually give 100% of the dynamics the source is producing, because there are no active components in the signal path, and it is not being loaded down.
All active components have a limit to be able to try to pass 100% of the dynamic input through their circuitry, this is why they all have specs that will never show "dynamic range"=unlimited. Or signal to noise = unlimited
Except if it is a purpose built dynamic range expander like the old DBX 118, but you would not want one of these in a high end audio setup, they sound disgusting.
Cheers George
If it is at or above 47k, the standard Lightspeed Attenuator WILL actually give 100% of the dynamics the source is producing, because there are no active components in the signal path, and it is not being loaded down.
All active components have a limit to be able to try to pass 100% of the dynamic input through their circuitry, this is why they all have specs that will never show "dynamic range"=unlimited. Or signal to noise = unlimited
Except if it is a purpose built dynamic range expander like the old DBX 118, but you would not want one of these in a high end audio setup, they sound disgusting.
Cheers George