PS Audio GCPH and Pass X0.2 not talking?

Audiomax,

Thanks for the suggestion of using a volt meter. I'll see if I can find one at Radio Shack.

Stan,

I'm in touch with Kent at Pass. So far, he's pretty baffled, too. Contacted PS Audio, as well, and they haven't a clue.

Audiophile,

I tried scenarios using single-end as well as balanced (when possible). Everything seemed to function either way. So, RCA from GCPH-to-RCA into headphone amp was OK; balanced from GCPH-to-balanced into power amp, also OK.

dead end.

What was the signal source when you tested the GCPH directly into the power amp?

With the GCPH into the X 0.2, what gain settings did you use on the GCPH and on the X 0.2?

Have you tried more than one input on the X 0.2?

Really stupid question: Did you have the correct input selected on the X 0.2?

There's nothing magic about the output signal of the GCPH - it's just another line level signal.

Ghost,

The signal source on the GCPH direct into the power amp was from the turntable.

Tried all four gain settings on the GCPH with no difference (no sound at all).

Tried Inputs 1 and 2: No sound. Immediately swapped out the GCPH and hooked up my CDP: Perfect sound.

Same as above: Selected each Input but nothing happened. Checked "Mute" too; it was off.

Taking the GCPH to a friend's house tomorrow to see what happens when hooked up to his equipment. I'll report results.

so just to get a clearer picture....
Have you tried hooking up GCPH to X0.2 with rca AND xlr cables(not at the same time of course)?
Have you used the same input on the X0.2 to test the CDP and GCPH?
Have you tried different inputs on X0.2 with GCPH?