Tube vs Tran

It's the combination of ingredients that you have to ensure works and not just quality of components.

Welcome back.
Spin the Yellowjackets.

Agree with Aball, get out and listen. Lots of good integrateds in that 3k range. What else are you putting together? Do you already have other components?

beerdraft

For Bob Reynolds.

You do NOT, nor should you connect a subwoofer in the manner you prescribed. The best method is connecting it directly from the speaker outputs of an amp. This is beneficial in two ways, the most of which is not loading down the preamp section. And this is plainly audible with most preamps.

Shakey

Many of us have had both SS and tubed equipment. Each offers it's own unique sound characteristics. On top of that you can alter the sound of tubed equipment by simply using different tubes. As far as I an concerned, Solid State is done when you buy it. Tubes will require replacement which is an added cost and they definitely will spark experimenting in tube rolling which is even a bigger cost. As Ncarv said, all good answers, but it comes down to personal taste!

Back to the original question of why would anyone ever buy SS when tube "sound so good". Many speakers benefit from the extremely low impedance at SS amps which causes a high damping factor.

Basically the damping factor rates the amps ability to control the physical ringing of speakers after a note has sounded. If you switch out amps while listening to a passage with lots of bass content, it'll be very obvious as you move from a low damping factor to a high damping factor or vice versa.

Vienna Acoustics, DALI and Sonus Faber are examples of speakers that are really designed to work best with a high damping factor and relatively high power.

Tube amps are sometimes described as having "woolly bass." This is probably because they were paired with a speaker that needed a much higher damping factor. Relative to tubes, SS amps tend to have higher damping factors, but they're not all equal. The Jeff Rowland 501 monoblocks have a damping factor of like 1000 into an 8 ohm speaker. That's very high (and you hear it) but a damping factor of 100 or 50 isn't unusual for SS amps.

Generally, if you hear a speaker with a woolly, ringing bass, it'll very likely benefit from being driven by a SS amp with a high damping factor.

Dave