Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
Hi Kevin, the distortion that the NSL32SR2S LDR's is .02%. This is also 2HD the nice one that tube amps and preamps give, but in a low feedback SE tube amp case this can be much higher at up to 2%. So as you can see .02% is nothing and it's the nice tube sounding one.
Also I saw that quote and it is also based I think using the Vactrol ldr which are inferior to the Silonex NSL32SR2S for both distortions and impedances.

Cheers George
Hi - With my lightspeed I still get significant volume when my volume knob is set all the way down. Is that because my speakers are 98 db efficient? I need to be able to reduce my volume lower.
Could also be that your amp is very sensitive and/or has high gain, as well as you source could have a higher output voltage than is the norm.
Or you could try a pair of the Rothwell inline rca attenuators, they come in -10db & -20db.
http://www.rothwellaudioproducts.co.uk/html/attenuators.html
http://www.decibelhifi.com.au/category42_1.htm
But I would prefer to go to the trouble of reducing the gain of the poweramp or source.

Cheers George