2. amps-preamps
  3. 1213372911

VTL MB450 monos Vs. BAT VK 60se monos?

I am currently using a solid state amp. I recently replaced a McIntosh SS pre-amp with the BAT VK51se pre-amp that I bought off AGON. WOW this move was a step in the right direction. Not a small step but a big one. So, I want to move to tubes for my amp too. These are the two set-ups that I am considering. Input would be greatly appreciated.
imformusa
trcnetmsncom
431 posts
 
Hello Imformusa,

Assuming the BAT VK-60se monoblock amps can drive your speakers properly my advice would be to .... go with BAT.

If you do decide to go with the BAT's it might be a good idea to get a fresh new set of 6c33 output tubes for them. Good luck to you whichever amps you choose.

Enjoy,
Tom
ejlif's avatar
ejlif
1,373 posts
 
I have owned both amps, though my BATs were the 150SEs. The BATs probably sound a little better, but they don't have the brute strength that the VTLs do. If you need a lot of power or are used to it you might be disappointed by the BAT amps. I personally would choose the VTLs on the fact that they have more power and I really like the sound of more power. The VTLs are HOT very hot, the BATs are hot but not nearly as bad. I personally had a fair amount of trouble with my BAT amps blowing fuses, where I had zero trouble with the VTLs. Incidentally I have moved to Parasound JC-1s and could not be happier (tubes, especially high powered amps are a pain in my opinion)
jfrech's avatar
jfrech
1,816 posts
 
Depends a little on you speakers and room. Source as well.

But I am partial to recommending you stick with BAT here. The VK60SE mono's are a steal for the performance and a perfect match for you pre amp.

The VTL's are great amps to, no issues there. Just the synergy gained from a BAT pre and BAT amp combo is something special I believe.

Good luck !
More to discover