2. amps-preamps
  3. 1217359572

Lead Weight on a Nuforce 9sev2

Question for all the Nuforce users. I have a problem with
the Nuforce 9 SEv2's moving around because of the stiff
cables and low mass of the amps. (Using Tip Toes under them)
The cables are JPS Superconductor 3.

Do you think there would be any problem putting some lead bars on top to stabilize them?

Thanks very much for any feedback!
ck
yoby
539 posts
 
CK. I use the large Little Rock mainly because I have owned it for the last 7 years, and it fits perfectly over the two amps. I have not tried two smaller ones.
stltrains
845 posts
 
Ck i'm using mapleshades heavy hat triplepoints on top of my V2s. I was using JPS SC 2s and they were very stiff so i know what you are talking about. The triplepoints are working very well for weight and vibrations. A fine tweak indeed for Nuforce amps IMO.
ck OP
101 posts
 
Stltrains,

Are you using anything under the amps for isolation?
vicdamone
850 posts
 
I'v got my SE's sitting on top of a combination of small inner tubes with suede covered DIY sand bags on top.

Vic
stltrains
845 posts
 
Yes Ck mapleshade triplepoint footers a maple platform sitting on isoblocks. You can see a picture at my system link. I also have installed emf material inside of the top cover of my amps, i also have ferrite rings under the amps. Enjoy the music.
More to discover