2. amps-preamps
  3. 1217636190

Best high current high power $5k amp for MBL 121

I've narrowed down my choice of amp(s) to the following to help me drive my MBL 121. The speakers are very inefficient at 82db and with a 4ohm load. I can consider amps for around $5k used but would like to spend a lot less if I can. Amps include:

Spectron Musician III SE Mkii
Plinius SA 250mkiv or 301
Pass Labs 250.5 or 350.5
Cary 500MB
McCormack DNA 500
Bryston 7BSST

I welcome any suggestions, especially from folks familiar with driving these speakers, and also welcome thoughts other amplifier options.

I play a wide range of music and varying volume. I'm typically a tube guy, and I value liquidity, airiness and naturalness above all else. I find I care little for pursuit of a low noise floor at the expense of other aspects of music reproduction. I find I don't particularly mind a sound that some may find colored if it breathes life to the music (I have a Supratek Syrah preamp that I love). I've had one or two highly regarded amps that may be considered accurate or transparenet, but which I found to be dead and lifeless.

Anyways, I welcome advice and input on what is an expensive purchase for me that I want to get right. I may also consider a far cheaper amp (a giant-killer, if there is one) that may not get me all the way there, but which will make do for a year or so as a good bridge to a better amp later on.

Finally, might there be a tube amp option for me? Again, I need a high power solution, and even moreso, I need a high current solution - to drive these speakers properly.

Thanks!
128x128outlier
dob
577 posts
 
If you have preference for tubes and I presume life-like sound then you simply have no choice among amplifiers you listed - Spectron Musician III SE Mk2. Its laso much better (sonically) then CAT and VTL high powered amplifiers.

All The Best
Rafael
outlier's avatar
outlier OP
381 posts
 
Thanks guys for the suggestions so far. The CAT would be to pricey for me alas, the Wolcott is an interesting idea I'll take a look at. Dob, I confess the spectron was at the top of my list - it's the one I'm leaning towards.

Another amp I thought of was a Moscode 401r - a hybrid design, and one where I could add a second amp later for mono configuration. Still though, perhaps the Spectron is the best bet. I'll need to keep an eye out for the right price used though, as it is beyond my budget anywhere close to the new price..
guidocorona
4,298 posts
 
Hi Outlier, I am extremely fond of the Spectron Mus 3 amp for its musicality, cleanliness of sound, and authority. In the same $5K range you may also want to have a good look at the Nuforce Reference 9 V2 SE monos which I also enjoy, although I have not been able to compare it directly with the Spectron. besides these devices sounding extremely good, they run very cool to the touch as their power conversion efficiency is over 90%. . . and having 'green' amps in times of soaring energy costs is not bad a thing at all at all at all! G. Just remember that there is no such thing as an absolute 'best'. . . there is only what you prefer. . . with your own ears, for the music you enjoy, in your own system. . . for the reasons that are important to you.
audphile1's avatar
audphile1
5,431 posts
 
My preference is for natural sound as well. Pass Labs X250.5 that I own for 2 years now fits the bill. I listen to a wide range of music, anything from Metallica to Mahler. The Pass has no problems driving my B&Ws, although they're more efficient than the MBLs. I doubt Pass would have any issues driving the MBLs. I looked at your system and you have very nice components. Another thing with Pass amp is that it is very transparent and lets you hear what each component before it is doing. I recently tried 3 preamplifiers in my system, and each time Pass revealed their strengths and weaknesses. It's a great amp.

Good luck with your search.
dob
577 posts
 
Hello Outlier,

Please be careful with Moscode 401. A few years ago, it was reviewed in Stereophile but John Atkinson noted that this amp will not be able to handle loads below 2 Ohms. to my surpise, the designer, in Manufacturer Respond section, agree.

While, very musical and involving this amp is not for your speakers. If you think about monoblocks then its probably even worse, since bridged monoblock sees only half the load.

Guido - I wonder very much if you have examined NuForce in speakers which are extremely difficult to drive?
As I recall, in TAS Nov 2006 issue - this amp was praised immensely by some reviewers and cursed by others.
So your experience would be of immense value.

Thank you in advance
Rafael
More to discover