Please recommend a high-powered SS amp


I'm on the lookout for a SS power amp that goes for $1000 or less (used) and puts out, say, 600W RMS into 8 ohms. Am I being unrealistic or do they exist?
khwarezm
Audiogoners, many thanks for your suggestions. I guess I should elaborate. And no, there's absolutely no show-off happening here. It's just that currently I'm driving my Proacs with an integrated SS Plinius 8200 MkII (175W rms/ch). Now beyond a certain point there will surely be clipping/distortion, which will be less at the same volume levels with a high powered amp. Doubling of RMS power takes the SPL up by 3 dB, so I gathered that a tripling would take it up by 9 dB, which is kind of a substantial perceptible difference. I want to be able to fill the room with high volume sound (at certain times) without the clipping/distortion, and I think higher powered amps may enable me to do that.
I'm surprised that you find the Plinius to be clipping. It's known to be a very gutsy amp. What Proac speakers are you using with it? Maybe the limitation lies there. If you want very high volumes, perhaps look into different types of speakers (such as horns).

If it's just a higher-powered amp you seek on a budget, I'd look into the old Carver Lightspeed amps.

Michael
Khwarezm,

Ah,now I get it .Certainly SET is out of question....

With Proac,I always find that Bryston[especially the 4bsst]give the best match.What you need is high current amp.....

Hope that help.
.....And try to control the resonance of your speakers and electronics with resonator-type feet like Finite-elemente/Harmonix tuning feet.You would be surprised at how wide and deep the soundstage suddenly becomes.

And lastly,I recommend looking at the speaker positioning..You would be amazed at how easy it is really,to fill up even large room once the speaker resonance is sorted out..

good luck
Khwarezm,

To get a 9db increase, you would need 8 time the power, and that is assuming the speaker itself does not begin to severely compress the signal (heating of the voice coil increases resistance) which it will do. The Proac speakers I have heard were quite efficient, so 175 watts would put them well into the point where speaker distortion, not the amp, would be a limitation.