How much power is to much power?

Baroque_lover probably doesn't need much power because, given his nom de plume, he only listens to baroque music. The demands are totally different from Mahler or even a Beethoven piano sonata.

He's right, he and I wouldn't buy the same systems because we have different priorities. IF you listen to very dynamic music, then power can be very important, particularly if you speakers can use the power.

Dave

Yes, some bloom in the bass is nice. I've found live music has "bloom" too. The question is not if you need added bloom. Rather, if your amp had some bloom, would that sound more like live music to your ears?

The Lavardin amp can indeed sound like 500W monoblocks if the speakers are *very* sensitive and have a flat impedance curve.

My NP100 Platinum feels a bit lack of power when I play Beethoven Symphony No. 9, especially towards the ending. This is a time that I wish I had more power......

A SET amp may not control a woofer at higher SPLs but that has little or nothing to do with damping, which is a function of an amps low output impedence.
TEST:: take a bare driver...woofer prefered. Thump it with your finger. Rings nicely, right?
Now, take a short piece of wire and short out the connections. Thump it again with your finger. Little or no sound, right?
The woofer basically damps itself when its 'load'...the output of the amp, has low enough impedence. The rest goes up as heat.
As for control, doesn't audible distortion play into this? If you had a dual trace scope connected and could compare the input signal and the actual speaker motions, you could visualize it. the traces match?=good 'control'.
Traces don't match? Bad control.

Exactly Magfan. High power with low distortion equals control. A high DF helps only slightly in the control of the driver. The amplifier starts the drivers, accelerates them and decelerates them and stops them, all at a complex variety of frequencies. Doing all that with low distortion and ample power is key to control of the drivers.

Dave

DF is simply load impedance divided by source impedance.

Nothing more.