2. amps-preamps
  3. 1225944893

Is it good to drive the magnepan 3.6?

I have 2 classe Twenty-Five power amp, and I just purchased a pair of Magnepan Speakers: model 3.6 and its rate is 4 Ohms speaker. I was wondering, if I "bridged" my power amp to function as "monoblocks" to drive a pair of magnepan 3.6. Will it cause the amplifier to "see" a 2-ohm load? Does that stress the amplifier's current capacity and will the amp be overheated?

Here is the power amp's rated output:
Rated Output :
8 Ohms Stereo: 250 Watts
4 Ohms Stereo: 500 Watts
8 Ohms Mono: 1000 Watts
4 Ohms Mono: 1600 watts

I don't have that much of experience on this audio system, so can any one give me some advice , please e-mail me.
Thank You
vinhd
herman
2,252 posts
 
Since Spectron gave the wrong answer and after he was corrected insisted he was right with a condescending comment implying I didn't understand basic electronics, and someone else jumped in with a smart ass response defending his wrong answer, how else would you have replied other than to give a detailed response? Just let it go so Vinhd was left with the wrong answer?

I always required my students to show their work. Formula sheets will be provided so you will not be able to use your notes.
macdadtexas
1,794 posts
 
Herman, I went to grad school at Rice and we had an honor system for exams, so I am going to ask to bring mine home!

I think this has been my favorite string to watch over the last week, maybe better than the election as far as banter back and forth.
herman
2,252 posts
 
I have also been entertained by it. You would think that someone who represents Spectron amplifiers would take the time to get the right answer on a basic electronics question before sticking their foot in their mouth twice. His comments about reducing all types of distortion as well as bandwidth and slew rate doubling were also incorrect but I figured if he didn't understand the simple stuff there was no reason to go into anything else.
vinhd OP
1 posts
 
Thank you so much for all of your help and advice. I appreciate you all taking your time and consideration in thoroughly answering my question. And again thank you.
ngjockey
1,042 posts
 
I've got a similar setup with bridged Plinius (which run hot normally) for planar magnetics. No problem. Maggies are nearly a purely resistive load across the bandwidth.
More to discover