Looking 4 good lower cost pre amp $300 to $600

This two channel and tube thing is kinda new to me. I have been a Home Theater geek for many years so I have to say I am learning another side of my hobby.

The integrated amp seems like a smart move perhaps. I was just going to use a spare amp I have laying around like my Chiro or Carver amps that where replaced years back by my reference HT amp. But to have it all in one package seems simple and more cost effective and perhaps more bang for the buck. I just think about only using one shelf on a higher end rack, one less set of stillpoints cones and one less Synergistic Tesla interconnect that can then go down to my HT setup.

I like the simple minimalist approach here. Am I onto something here! Are integrates a good way to go and more cost effective? Tubes do sound very appealing also.

Thanks!!

11-11-08: Freemand
I have some Highly modded redone Kef ref 104/2

Redone with different drivers and/or crossover? If so, it might be hard to know what the specs and impedance curve are now. The original 104/2 specs were - 92dB/W/m at 4 ohms, 55Hz to 20kHz (+-2dB).

Since you are a fan of midrange, tube integrated seems a natural choice and the 92dB efficiency is a fairly easy load provided there aren't some big dips below 4 ohms. And the 55Hz lower limit should save a low-priced tube amp from having to produce the hardest frequencies.

Anyway, in your price range, you might want to look for a Jolida tube integrated in the 40-60wpc range like the JD-302B(50wpc) using EL34 tubes that's for sale here at $595. EL34's are pretty meaty output tubes, soundwise and do a good midrange.

Darkmoebius,

Thanks for the details. Helpful info!

I bought some of scan speaks higher end woofers for the inside. Redo all the wiring. Isolation to the cabinet of both the crossover and the mids, tweeter pack. Tons of resonance control among some other tweaks. I would still think the db level would be about the same.

I do plan on using a sub.

Thanks everyone for your feedback. I have checked all these units out.

I have a Musical Concepts Mc3-T pre amp I will be listing soon. It is a very good ss pre that I just had rebuilt new caps,transistors(blackgates) seperate power supply phono redone at a cost of $350.00 This pre list for $1600.00 and out performed pre at much higher cost. Google for info. If you have interest I will sell for $400.00 Steve.