Which is the most tubelike solid state amp around


Being a tube person who is trying to put together an active loudspeaker setup , I have come across the problem of choosing the best driver for the midrange and upper bass i.e.80Hz to 2.5 KHz. I would like to try a panel such as a Magnapan but am told that they are rather power hungry. Therefore, I would be grateful if fellow Audiogoners could share your experience in relation to the best powerful SS amps that would not be out of place in a "tube-ophile's" system.
Thanks
ecka
in the context of current production tube amps, perhaps, excluding low wattage sets, a ss amp which does not evince the objectionable characteristics ascribed to the sound of transistors, would connote a tube-like sound.

the "modern tube" design more closely resembles the sound of many solid state amps, than the earlier so-called "classic tube designs".

my experience with solid state amps points to an impression that most solid state amps have an annoying presentation of frequencies above 1000 hz.

while annoying is imprecise, it would seem that when generating spls exceeding 85 db, solid state amps, especially with panel speakers, exhibit an aggressive upper mid/lower treble presentation.

the only time i have actually enjoyed solid state equipment,was the combination of the early avalon ascent or avalon eclipse, mated with rowland amps and preamps. however, i suspect that the avalons, were solid ss friendly.

thus, i would be more concerned about the speaker than the ss amp. selecting a ss friendly speaker may render the selection of a ss amp, much easier, e.g., some of the vandersteens.
Post removed 
Every time I have had the Bybee products in a piece of gear,I have removed them.It does some subtractive tricks,but diminishes from the over-all sound.
If you should decide to "try" these,make sure they can be removed.
I believe that HP/TAS remarked on this very same subject.
hi tvad:

thank you for reminding me to be objective.

my point regarding the difference between solid state and tube amps is that there is a sonic signature which is evident when listening to solid state amps, which makes it possible to identify the amplifier as solid state. the region, 1000 hz to 3000 hz, is the range which disintguishes the sound of many solid state amplifiers from many tube amplifiers.

there are two questions, how to precisely describe the difference and what parameters to measure.

one of the challenges of audio is the correlatation of (subjective) listening experiences with the appropriate quantifiable variables. i can not specify what to measure, only to suggest that the range covering upper midrange and upper treble fundamental frequencies and their harmonics may be worth measuring.

perhaps, i would hypothesize that there are measurable differences between the harmonic envelopes based upon the aforementioned frequency range which can distinguish a tube amp from a solid state amp.

if so , it may be difficult to find a solid state amp that is tube like. of course, what tube amp would be used as the benchmark ?? would it be a design from the 60's through the 1980's or a current production tube amp ?

i am afraid i have raised more questions than have answered them.

i will conclude by saying that the quest for a tube-like solid state amp, requires very spefici facts, which have yet to be mentioned, including, what tube amp sconstitutes the benchmark for "tube-like" quality, or would there be more than one tube amp, since there are differences between tube amps, and what is the criteriaon for "tube-like character " ?

you can blame tvad fror my rambling. thanks again tvad for reminding me of my principles. i sometimes fall into subjectivity--sorry about that.
Hello Tpsonic, I also experienced some small artifacts in first generation of Bybees products - certainly not with the latest Super Effect Bybees.
Did you have experience with SE BYbees?
Thanks