I'd go with Herbies feet..They seem to have it covered very well with there footers etc...Good products that are not expensive...Temporarily just cut up some small feet from and old ( hard wood ) wooden broom handle..
Where to get replacement Rubber Feet?
Instead of modifying my exisintg rack to fit my new amp, I would rather obtain some new (smaller height) rubber feet for my 70lb amp.
Does anyone know a source where I can get a 1/2" (approx) tall set of rubber feet?? All my searches have yielded only high end isolation products.
Does anyone know a source where I can get a 1/2" (approx) tall set of rubber feet?? All my searches have yielded only high end isolation products.
- ...
- 11 posts total
Digikey. See "recessed bumpers" on the following page: http://dkc3.digikey.com/PDF/T083/2230.pdf Regards, -- Al |
I have routinely replaced rubber feet on my equipment as required with rubber and or plastic feet from Outwater Plastics Industries, Inc. (www.outwater.com) Whereby their rubber feet are only sold in diameters up to 1", their plastic case feet are available in diameters up to 1-1/8" Check out catalog page (bottom of the page) as follows: http://www.outwatercatalogs.com/2008_Master/lg_display.cfm?page_number=258 Self adhesive "Bumpon" products are quite effective for this type of application as well (Online catalog pages 238- 241). ~Joey |
- 11 posts total