Krell FPB 300cx vs Jeff Rowland 501's?

FWIW, soundwise, I'm thinking its more a lateral move albeit an energy efficient one with a bit more power.

Might open up dynamics a bit and go a bit louder.

I'd expect the Rowland to be a bit smoother though if the current setup has an edge to it.

I think Krell/B&W is a good match off the cuff though.

That Rowland, a classic ICe amp without an analog power supply, will be dependent upon quality of the A/C power supply, while the big 'ole Krell, with its beefy analog power supplies, will be much less so.

The Krell is probably 400-425 watts/channel into 8 Ohms, the Rowland roughly 500. That's not going to get you any practical increase in headroom over the Krell (doubling wattage yields only a 3 db. increase in output).

You would likely have greater midrange clarity with the Rowland, which is an ICe amp module characteristic, but you would trade high frequency purity, which is an ICe amp module weak point that shows up in the Rowland 201/501 implementation.

The Rowland is of course much more energy efficient, if energy bills are an issue for you.

In short, while I have not heard either amp on your speakers, my guess is that you would merely be swapping flavors. If additional power is your goal, I would buy a much more efficient speaker that plays big (e.g., WattPuppy 6, 7 or 8, or Escalante Fremonts), as you really need to spend a lot of money for amps that will give you a significant increase in headroom over what you have. PS - I have nothing against Rowland equipment - I have run a Rowland preamp for nearly six years and used to own Rowland amps.

The JRDG 501 are undoubtedly very fine amps to start with. . . loads of controlled power to drive any load and a very open and easy to listen sound. For the reasons explained by Raquel above, if you want the ultimate out of the 501 monos, you need to add to them a pair of external JRDG PC1 active Power Factor Correction (PFC) units. These devices preconvert the AC from the mains to a steady 384V DC current fed into the monos through a banck of intermediate charge capacitors and make the 501 much less sensitive to AC noise and fluctuations. They also keep the 501s internal caps optimilly charged avoiding AC induced ripples. PC1s should yield even larger authority to the 501s and will give them a lot more subtlety and nuance. It is said that the PC1s let the 501s approach the performance of the JRDG 312 stereo flagship, which is my very fav amp of record. The PC1 is not on the jeffrowland.com website yet. Your dealer can order them for you. They list for $1500 each.
I wish I could answer your question more completely and directly. Unfortunately I can't compare the 501s with your Krell, as I have no direct experience with the FPB 300cx . Guido