buzzing from speakers

Kijanki, I agree it depends on what we're touching. I was referring to the metal casing and switch at the front panel of the amp when I mentioned it is unlikely the component will be damaged with ESD when touching them with bare hands. I wouldn't risk touching the inputs and outputs of the amp at the back panel with my fingers when the amp is running and risk frying myself. In this case, you are correct that the amp or speakers may be damaged. However, this is more towards plugging and unplugging interconnects when the amp is not on standby mode whereby this static electricity will send a loud pop to the speakers that may damage the tweeter or drivers, or the amp. I hope you are referring to this as I believe components won't get damaged if we touch them(the metal casing or knobs at the front panel) that subsequently cause this ESD to take place.

To minimize or eliminate shock when touching the amps, I am now more prudent by touching some wood before I touch the switch on the amp.

Ryder - "Believe" is the right word. Static might zap the input (or output) if you touch it even if you turn equipment off. Damage to speakers was just an example.

Analog Devices application engineer told me once that they had problems with customer's A/D converters loosing linearity after being zapped by static. To me it is even worst than damage (that can be repaired).

This is one of the most amusing threads I've ever been a part of... If the amp is properly grounded a static discharge from you to the case is going to pose no threat to the amp. You're erroneously imparting a level of concern here to the original poster that's totally unfounded. He's not opening the case and zapping internal components for crying out loud.

You don't need to open case to create static damage. Even with properly grounded equipment it might happen if voltage is high and it is repeated many times. You'll find testimony of that here on Audiogon forum. I am able to destroy prototypes of industrial electronics zapping them few hundred times with 10-20kV zapper to heavy metal case that is grounded directly to copper ground rod (not the flimsy inductive 3th prong). It is not issue of "IF" but rather "WHEN". Situation of repeated static discharge is unacceptable.

It gets much worse if you touch something else than case - like metal knob sitting on the metal shaft of the volume pot and not touching case (small gap). Or even better zap speaker wire (and I assume that grounding is non-inductive and perfect).

If you read more about static damage - one of the first thing advised is humidity control. You'll find many posts of people who damaged their computers by strong discharge to a case.

Stay amused!

"Stay amused!" ... oh, I am ...