Why do my ears ring with my new amplifier?



I just changed integrated amplifiers on January 2, 2015. I went from an Audio Research DSi200 to a Simaudio 600i. I'm running a Lumin A1 Network Streamer and Dynaudio C1 speakers. Those haven't changed. I'm also in the same 10' x 12' room.

My setup sounds great when I'm outside of my room. When I walk in and sit down, my ears start ringing.

I don't think that the high frequencies are the problem. Is this too much bass energy in the room, too much sound pressure, or what do you think?

Does anyone have a suggestion on what's needed to correct this problem?

Thanks,
Chuck
illuminator
One end of your room needs to be dead. You may trying covering the wall behind your listening chair with some sound absorbing material after adjusting the rake angle of the speaker. One position is not ideal for all amp/speaker combinations. Try raising the front up a bit and see if the music changes.....better or worse....dial close, then room treat. PT
I have tinnitus and in the beginning, it would happen at random times and in different ears. Now that I'm older it's permanent, but rarely interferes with a listening session.
I think you need to use sound absorption and deadening the rear wall is a good experiment.
Thanks everyone!

I'll start with spreading out my absorption panels behind my chair to have a wall of 6" panels.

I'll also check out the speaker toe-in and rake.

I'll also see if I can listen at lower volumes and pick out the quiet passages easier.

Chuck
I wonder if using headphones would work as a troubleshooting tool ? It could rule out any components.
"02-04-15: Lowrider57
I wonder if using headphones would work as a troubleshooting tool ? It could rule out any components."

It's a very good idea, but I don't think it would be too reliable. There would be no way to tell if the ringing is caused by the room or the system.