2. amps-preamps
  3. 1238086391

90db, 7ohm speakers: tube amp recommendations?

HI,

I have the new Tyler Acoustics Decade D1's, and they sound very, very nice (still breaking in, but so far, couldn't be more pleased). I was considering a tube amp with them, would be paired with my McCormack ALD-1 Revision Gold+. I was thinking about a lower-powered push/pull design, something with over 20 watts obviously, but I don't need a ton of power for these. Room is around 400 square feet. Any good ideas? Budget is $2000 or so (used). Saw a Canary 301 that had been upgraded (22wpc, lots of current capability) but it sold very quickly. I was also considering higher powered KT-88 designs, but have been told that I may do better with a a bit lower powered amp, vs, say a ARC VT-100 MKii.

Looking for a fairly full, musical sound, but not too bloomy or warm. These speakers are extremely transparent yet musical, and I want to continue in that direction; a bit of tube fullness, but with no loss of soundstage or detail. It will be more or less to try: my upgraded (by SMC) McCormack DNA-125 amp currently sounds superb, but it would be nice to try something else for a bit.

dawgcatching
vett93
205 posts
 
At least, you need to find out the minimal impedance of your speakers. I have two pairs of speakers, both rated 91dB@8ohm. They sound night and day different with my 50W KT88 monoblocks.

One pair has a flatter impedance curve and these 50W KT88 monos drive them nicely. But then with my JM Lab Alto Utopia BE, its impedance drops to 3.6ohms at lower frequencies. These KT88 monos are very inadequate for Alto Utopia.

I use Counterpoint NP100 to drive them. NP100 is rated 100W@8ohm and 200W@4ohm. It is barely enough for the Alto Utopia!

So like Newbee said, you need to investigate more.
dawgcatching OP
139 posts
 
I was told the minimum impedance is around 7ohm, nominal is 8ohm, with a flat curve that is "easy to drive". I haven't seen specs on them, but from listening so far, they are driven very well with my little 125wpc SS amp, whereas my previous speakers needed more juice.
atmasphere's avatar
atmasphere
12,158 posts
 
Dawgcatching, most tube amps (including the M-60s) will drive that fine with no worries.
pubul57
3,712 posts
 
Agree with SBank. The Atma-spheres would work great. Or, for a bit less, and currently selling for only $1,450 on sale, the Music Reference MR10 MKII - 35 watts with EL84 tubes - both great designers and wonderful gear. Can't tell you which you would like better. But you can't go worng with either with those speakers.
stonedeaf
101 posts
 
Quicksilver Monoblocks - they're available used for within your price range. Really wonderful amps - even my relatively ancient KT-88 monoblocks are pretty amazing driving 89db efficient Studio 20's. Word to the wise - always retube used amps -have no idea why so many tube amps only have "around" 200 hours on the tubes - must be a pretty rough couple of hundred.
More to discover