Can someone tell me the Class of my Tandberg amp


I was wondering if someone with a little more expertise could chime in and look at the diagrams and figure out what class the amplifier is. I know that the class A's are usually the most sought after, or AB. Isn't this a classification of their efficiency? If so why does it translate into better sound?

Thanks Again,

Nate
nate_d
Visit the following link to learn about classes of amplifier operation.
http://electronics.indianetzone.com/1/amplifier_operation.htm

.
One or more points are missing from the link provided by Gbart:
One of them is shown notch distortion in class B which barely means a thing.
It can be equal to distortions of class A due to non-linear transistor output characteristics. The larger 'range' of output is utilized the larger distortions are such as the shape of positive sine-wave may be different from the negative i.e. not as symmetric as shown. To reach the output signal 'closer' to ideal, only the small portion of transistor output characteristics can be utilized hence limiting the output power of amplifier.
In class B symmetry becomes less of the issue as long as transistors are matched or there are complex circuits of DC offset optimization between a pair of transistors.
The fact that the link above somehow explains the amplification classification (mainly for ss amps; tube amps have similar such as push-pull or single-ended) and partially answers your question should less-likely affect your opinion to the amplifier you own.
The only important facts of the amplifier should be synergy with source and speakers
Leaving theory and implementation aside, all things being equal (which they rarely are) Class A operation generally sounds better. I don't think the schematic will tell you anything, but if you turn the amp on (safest if connected to a load) and leave it on for 15-20 minutes w/o actually passing a signal thru it, you should be able to tell immediately. Amps that operate in Class A would be v warm to hot at idle. If the heat sinks or case over the output devices is only warm, its not class A. Also if the case does not have any external heat sinks, that is a clue that its A/B. For what its worth, I don't remember any Tandberg amps operating in pure Class A but its been a long time so I could easily be wrong on that one.
Post removed 
I too don't think that Tandberg ever made a pure Class A amplifier, and just a small minority of amplifier manufacturers have.

I suspect from your other recent post that you are referring to a Tandberg 3003, which is rated at 2 x 165 watts into 8 ohms, and 2 x 250 watts into 4 ohms, and weighs about 25 pounds.

Those figures alone indicate that it is not even close to being pure Class A. The Pass Labs XA160.5, for example, which is Class A and puts out 160 watts into 8 ohms, weighs 150 pounds for EACH single-channel amplifier. As Elizabeth said, true Class A amplifiers "are BIG heavy monsters."

Regards,
-- Al