There are two sides, one for each channel. So you would need to place 2 jumpers, one on each side that marks 100ohm.
Setting up Pro-Ject Tubebox SE II
I have a Lyra Dorian MC cartridge paired with my Pro-Ject Tube Box SE II. According to the cartridge's specs:
Recommended load direct into non-inverting RIAA equalizer amplifier or head-amplifier: 100ohms - 47kohms (determine best impedance value by listening)
According to the tubebox instructions:
"MC - 100ohms/120pF (jumper on 100 Ohms)"
My question stems from the fact that there are two sides to place jumpers* on the back of the tubebox yet the tubebox instructions speaks in the singular, it does not say "jumpers" -- thus am I supposed to only place a jumper on 100 Ohms on one side? I'm confused as to what the "load" actually does anyway.
Help would be very much appreciated.
Thanks!
*Picture of the back of the tubebox:
http://tinypic.com/r/nxkm10/3
Recommended load direct into non-inverting RIAA equalizer amplifier or head-amplifier: 100ohms - 47kohms (determine best impedance value by listening)
According to the tubebox instructions:
"MC - 100ohms/120pF (jumper on 100 Ohms)"
My question stems from the fact that there are two sides to place jumpers* on the back of the tubebox yet the tubebox instructions speaks in the singular, it does not say "jumpers" -- thus am I supposed to only place a jumper on 100 Ohms on one side? I'm confused as to what the "load" actually does anyway.
Help would be very much appreciated.
Thanks!
*Picture of the back of the tubebox:
http://tinypic.com/r/nxkm10/3
- ...
- 2 posts total
- 2 posts total