Wire the House A/C or get Power Conditioner?

I agree with Rushton and Rodman99999.
If you check out my power filtration system set up in my system on Audiogon you will see that I filter all AC power with two 5 KVA isolation transformers before the AC gets to my dedicated lines. That power feeds three different high end audio systems in the house.
I started with dedicated lines and liked what I heard with in the music. Added the Isolation transformers and the sound improved more so.
So, if you own your home I'd start with dedicated lines and good AC outlets, and then add to it as money is available.

Do both. But if money and laziness is a factor, get a regenerator and good power cables, especially to use as input to the regenerator.

The best way forward ultimately has already been outlined above. (dedicated single runs of good quality cables from your main box, with good quality outlets and conditioning/regeneration.) It all adds up in both price and performance but once it is done you can forget about it.

Thanks for all the comments. I think I will wire the house first.
Do I use the wire from off the electicians truck, or buy special (expensive?) 10ga wire? Also where can I get the cryo'ed AC outlets?
I have also read that you shouldn't staple the wire under the house. Is that important?
Thanks, Scott

You can carry this to any extreme of excess you're inclined to pay for. In my experience doing this three different times in different houses, you'll get very good improved results by using a standard 10ga solid copper wire. The biggest improvements will come from

- pulling direct home runs from the breaker panel (no intervening breaks or splices),

- using a separate home run cable for each receptacle,

- having your electrician apply Walker Audio Extreme SST contact enhancer on each connecton from the breaker to the receptacle (not kidding here),

- having the electrician clean and tighten the connections at the grounding rod and at grounding bar inside the circuit box, and if there is any question about the grounding rods, driving new replacement copper clad grounding rods, and

- installing cryo'd Porter Ports or Synergistic Research TeslaPlex receptacles. If you can install non-ferrous boxes for the receptacles, do this too.
.