Tube Preamps


I was wondering opinions on whether or not a tube preamp might fix or reduce my overly bright sounding system. I am currently sourced by a Rotel RCD_1520 with Rotel RB-1582 2x200 watt amp, Rotel RC-1580 preamp with B&W CM7 speakers. I know the speakers are a tad bright, but when I disconnect the Rotel amp/pre and reconnect my old NAD c317 integrated, it sound great. I like the warm sound and deep bass of the NAD. Isn't the amplifier just amplifying what it receives from the preamp? Is it possible for an amp to be bright?
donjr
Yes, your speakers are a tad bright and it's very possible for an amp to sound bright too... and pretty likely if it's solid-state. Some sound brighter than others. Yes, flat response is the goal, but you probably wouldn't like it if you heard it anyway.

A tube preamp could help if mellow-sounding tubes are used, but the bass will be less deep and distinct. I'm sure the tone controls on the NAD amp help out... if it has a preamp output maybe you could try the preamp output into the Rotel amp's inputs. That way you could simply turn down the treble. Do you have a nice padded rug on the floor???

Good Luck
Yes, in general a tube preamp, or tubes somewhere in the chain will reduce brightness or glare. At least that has been my experience. Something else I do that tames my speakers is I cut some felt to place around the tweeter...so it sort of looks like a bagel with nothing touching the dome itself......I can't expalin why, but that helps eliminate some of the edge in my room....I don't have an extremely expensive set up, but it is comparable to yours. Good luck. The felt makes my system less aggresive without a significant side effect.
I don't mean to ask the obvious but if you like the sound of your NAD integrated why not stick with that or go foe NAD's separates?
Plato said, "Yes, flat response is the goal, but you probably wouldn't like it if you heard it anyway."

An audiophile paradox from the philosopher Plato.

So if the goal is a flat freq response, why then would it not be what we want.

Bob
Ya,stick with the NAD like Cmalak says..I second that.

I always thought the rotels had more grain and are bright..

A good tube integrated might be what you would like???

IMO,I think a lot of people cant name what there looking for in HIFI.

I think it's tone,the tone had to be right,not alot of hifi has good tone...

I have found tube amps to have superior tone by a mile.

With that said,the solid state amps that I found to have good tone are Accuphase,Forte 4,threshold,some early NAD's.
Arcams OK. I know there are more....

Quote:
"Isn't the amplifier just amplifying what it receives from the preamp?"

Yes,and some amps do it much much better than others.

I now run Quicksilver's,
American made, hand made, tube amps,mono blocks

they have outstanding tone(natuaral tone),low level detail,depth,musical up the yinyang.
The cost me a measily $800 off eBay too.
So,super duper sounds dont have to cost a small fortune...

Keep posting question and learning!!

Good luck!