Running 4 speakers from a 2-channel amp

Thanks Kijanki . . . A good explanitation of why it can be appropriate to wire speakers in series under certain circumstances. It should be noted the main assumptions/limitations . .

First, it makes the loudspeaker performance more variable with manufacturing tolerances, so in i.e. the D'Appolito array mentioned the effective tolerance for the drivers themselves must be better than for the parallel connection to get the same average results. And for a professional sound reinforcement application, there's one-quarter the statistical redundancy in the event of driver damage.

Second, it assumes that the driving source (amplifier) have essentially a zero output impedance. Although one wouldn't expect to see an SET or OTL amp for this kind of application, series volume controls should definitely be avoided, especially because they introduce enough frequency-response variations of their own.

So for something like putting four pairs of identical outdoor speakers on a single receiver ... The series/parallel scheme works great, provided they're hooked directly to the (typical solid-state) amplifier.

Kirkus - I remember seeing large bass guitar stacks that had a lot of small (about 10") speakers (10-12). They must have been connected serial/parallel to obtain any drivable impedance.

I've read on this forum that before SS popularity speakers/drivers had very high impedance (16 or even 32ohm). Maybe it was to match better with tube gear but it could be for other reasons. Lower impedance allows to squeeze more power from SS amps.

Kirkus - I remember seeing large bass guitar stacks that had a lot of small (about 10") speakers (10-12). They must have been connected serial/parallel to obtain any drivable impedance.

Actually, just about every instrument cabinet I can think of is parallel connected . . .the classic Ampeg SVT bass cabinet used eight 10" 32 ohm speakers, and I think the modern versions do as well. In Fenders, many of the differences between the (ostensibily very similar) amplifiers used in heads and combos were different output transformers . . . i.e. a Super Reverb combo had 4 8-ohm speakers, and the amp had an OPT designed for a 2-ohm load.

I have had fantastic success in running speakers in series.

I have a set of Klipsch 5.2 with a 12, 10, and a medium size horn.

Loving the nice low end response, the 5.2 lacks the mids and the sensitivity in the highs that I get from a set of 3.2's which have a 10, 8 and a smaller horn.

The 3.2's have very nice mids, decent highs, but lack body on the low end.

I simply stacked the 3.2's ontop of the 5.2's running off an old Scott Tube amp, and I am now getting the best of both worlds.

So any theory about destroying your sound by running two sets of speakers in series is not an absolute universal concept. It's working fantastically for me.

i'm 64 years old and don't know too much about equipment. back in the early 70's i had a 4 chanell receiver with 4 bose 901 series 2 connected in parralell lowering it to 4ohms. in 2000 i bought a mcintosh mc2205. in 2011 my son gave me his mc602. i have my bose positioned the way the "super bose system" was in the 70's. "no lows, no highs, must be bose" is what i read today. no funds to upgrade so i'll have to settle with the bose.