Rating tubes is way overrated. The only way to test them accurately is in circuit with a distortion analyzer, and listen to them. Who cares what the numbers show if they buzz or have high distortion. they can check fine and still buzz or be high distortion. Tube checkers area yes or no to a tube being dead, or near dead. Tube buyers are only getting some of the information from tested tubes. RAM and Upscale Audio are a few of the places who do very thorough testing and I believe Jim McShane also does thorough testing. Jallen
A couple of questions about testing 12AX7 tubes.
I have been testing a bunch of RCA and some Fisher 12AX7 tubes on a Hancock tester at the local Antique Radio Museum. Two things happened while testing the tubes that I am not sure about.
The first thing that happened is that 3 of the tubes (out of the 15 that I tested) glow bright right after plugging them into the Hancock tube tester, then the immediately go down to the normal tube glow. Does this indicate a bad tube? One of the RCA long plates and two of the Fishers did this.
The second question is that while testing the triodes of 2 tubes the meter went all the way to the right and was pinned on the meter, which goes up to 3000. On one of the tubes both triodes pinned, on the other tube one triode pinned and the other read around 2800. Is this good or bad? Do I just have excellent tubes or is there something wrong with them?
Thanks for your help.
Joe
The first thing that happened is that 3 of the tubes (out of the 15 that I tested) glow bright right after plugging them into the Hancock tube tester, then the immediately go down to the normal tube glow. Does this indicate a bad tube? One of the RCA long plates and two of the Fishers did this.
The second question is that while testing the triodes of 2 tubes the meter went all the way to the right and was pinned on the meter, which goes up to 3000. On one of the tubes both triodes pinned, on the other tube one triode pinned and the other read around 2800. Is this good or bad? Do I just have excellent tubes or is there something wrong with them?
Thanks for your help.
Joe
- ...
- 4 posts total
- 4 posts total