2. amps-preamps
  3. 1273513906

Will a Wattgate 20A IEC female end fit AR VS115?

I found to my chagrin, that a Furutech 20A IEC plug on an aftermarket power cord will not seat all the way on my AR VS115 amp because the fuse holder protrudes right above the amps power receptacle. The main body of the Furutech butts up against the protruding fuse holder before the plug can seat fully. The Wattgate has a low shoulder between body and plug, which may be just enough to allow full seating. If anyone is using a Wattgate with success on a VS115, please let me know. I plan to just rewire the cord.
shuteye
jea48
4,605 posts
 
http://www.arcdb.ws/VS115/ARC_VS115_back.jpg
piss poor design by ARC....
gbart
290 posts
 
A Schurter 20A IEC plug should fit.

http://www.cryo-parts.com/schurteriec.html

.
shuteye OP
16 posts
 
I agree, piss poor design for sure. Never considered it until I went to plug in my A'gon purchased DCCA reference master. Now just need to find out regarding the Wattgate. A bit of an esoteric question, I know.

Gbart, I don't believe the Schurter will take the heavy guage copper in the DCCA - it is one stiff, heavy cord. So much so that I would only use it for an amp or power supply, even if it had a 15A end.
Post removed 
More to discover